Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
theshop [2018/10/02 16:53] zashi [Phase 6: Power] |
theshop [2018/12/20 16:36] zashi |
||
|---|---|---|---|
| Line 151: | Line 151: | ||
| | Building | $7,960.00| $7,981| | | Building | $7,960.00| $7,981| | ||
| ^ Total ^ $11,710.00^ $11,481^ | ^ Total ^ $11,710.00^ $11,481^ | ||
| + | |||
| + | |||
| + | ====== NEXT STEPS ====== | ||
| + | The shop has been built. Now, how to make it useful? | ||
| + | |||
| + | ===== Floor ===== | ||
| + | Mitigate moisture and it's a bit prettier than straight concrete. | ||
| + | |||
| + | - Etcher ( from kit below ) | ||
| + | - [[https://www.amazon.com/Rust-Oleum-301239-Moisture-Stop/dp/B01LQTXPQY/ref=sr_1_1?ie=UTF8&qid=1543604583&sr=8-1&keywords=rust-oleum+moisture+stop|Moisture Stop]] | ||
| + | - [[https://www.amazon.com/Rust-Oleum-261845-EpoxyShield-Garage-Coating/dp/B006ZUZ9QE/ref=sr_1_2?ie=UTF8&qid=1545323636&sr=8-2&keywords=rustoleum+etcher|Epoxy ]] | ||
| + | |||
| + | ==== Tools ==== | ||
| + | * Spreader | ||
| + | * shoe tacks | ||
| + | * solvents for cleaning up | ||
| + | * buckets | ||
| + | |||
| + | |||
| + | ===== POWER ===== | ||
| + | |||
| + | - Either EMT (electrical metal tubing) to route around the shop. | ||
| + | - 100A Breaker box - suitable for branch from house or own box (need to research if Duke power does cheap meters for workshops/garages) | ||
| + | - LED over head lights | ||
| + | - I could include a transfer switch and use the generator to power the workshop--it's added cost but will let me delay the cost of getting a mains hook up. | ||
| + | - The workshop seems like the perfect place to experiment with DIY solar power tie-in. Boy, I'd love to have a stack of salt-water batteries. | ||
| + | - In the very least some deep-cycle batteries for running ventilation fans seems like a good idea | ||
| + | |||
| + | ==== Required tools ==== | ||
| + | |||
| + | - Conduit cutting tools (probably already have an adequate saw, but a purpose-made tool will speed things along) | ||
| + | - Conduit bending tool (good for other stuff too!) | ||
| + | - 12' ladder for running wiring and lights | ||
| + | - Proper wire strippers (going to be doing a lot of stripping, time to get a good pair of strippers) | ||
| + | |||
| + | |||
| + | ===== Big Ticket Tools ===== | ||
| + | |||
| + | I'm sure I've made this list in a dozen places already. | ||
| + | |||
| + | - Table saw | ||
| + | - Band saw | ||
| + | - Stick welder | ||
| + | - Miter saw | ||
| + | - Drill press | ||
| + | |||
| + | |||
| + | |||
